When your heat goes out on a cold Tennessee night, you need a team that answers. The Comfortable Crew provides fast furnace and heat pump repair, tune-ups, and new heating installation across Collierville, Germantown, Memphis, Bartlett, Arlington, Cordova and surrounding communities — with 24/7 emergency service.
Furnace & Heating Repair
We repair every type of heating system — gas furnaces, heat pumps, and more:
- Furnace not turning on or not heating
- Blowing cold air or short cycling
- Pilot, ignitor, or flame sensor issues
- Loud noises or burning smells
- Heat pump not keeping up in cold
Furnace Replacement
Older furnaces waste money and can be unsafe. We install high-efficiency Trane gas furnaces and heat pumps — properly sized, cleanly installed, with financing available.
Have a heat pump? See our dedicated heat pump repair, maintenance & replacement services.
Heating Tune-Ups
A fall tune-up catches small problems before they leave you cold and keeps your warranty valid.
Signs your furnace needs attention
Heating problems tend to get worse — and always seem to fail on the coldest night. Call us if you notice:
- No heat or air that never gets warm
- Short cycling — the furnace turns on and off repeatedly
- Yellow or flickering burner flame (a healthy gas flame is blue)
- Loud banging, rattling, or a burning smell when it runs
- A spike in your gas or electric bill
- Your carbon monoxide detector going off — leave the home and call 911, then call us
Repair, tune-up, or replace?
Not every furnace problem means a new system. A dirty flame sensor or a worn ignitor is an easy fix. But if your furnace is 15+ years old, needs a major part, or you're paying for repairs every winter, a new high-efficiency Trane furnace or heat pump usually pays for itself in lower bills and fewer breakdowns. We give you an honest recommendation and a free estimate — and we never pressure you into a system you don't need.
Heating & Furnace FAQs
Why won't my furnace turn on?
Start with the basics: make sure the thermostat is set to HEAT and above room temperature, check that the furnace power switch is on, replace the batteries in the thermostat, and check the breaker. If it still won't start, it may be an ignition, flame-sensor, or safety-switch issue — don't open the furnace yourself. Call us at (901) 262-5931 and we'll get your heat back.
Why is my furnace blowing cold air?
Common causes are a thermostat set to 'fan on' instead of 'auto', a dirty flame sensor, an ignition problem, or a safety shutoff from overheating. We diagnose it fast with upfront pricing.
How much does furnace repair cost?
Common furnace repairs typically run from about $275 for a small part like a flame sensor or igniter up to $1,800+ for a major component like an ECM blower motor. You get a flat, upfront price before we start — you approve it first.
How much does a new furnace cost?
A new furnace typically runs from about $5,000 to $10,000+ installed, depending on size, efficiency, and fuel type — with value and high-efficiency options available. Full system and dual-fuel replacements cost more. We size it to your home and give a free quote with financing available.
How long do furnaces last?
Most gas furnaces last 15–20 years and heat pumps 12–15 years with regular maintenance. Past that, efficiency drops and repairs add up — a good time to consider replacement.
What size furnace do I need?
Furnace size is measured in BTUs and depends on your home's square footage, insulation, windows, and our local climate — not just a rule of thumb. We do a proper load calculation so your system isn't over- or under-sized, which affects both comfort and bills.
Do you offer emergency furnace repair?
Yes — 24/7 emergency heating repair across Collierville, Germantown, Memphis and surrounding communities.